Thingiverse
creator pro 2 leg extender
by _voidarc_
0
Downloads
0
Likes
0
Makes
Print Instructions
Recommended Material: TPU
Alternative Material: PLA (works, but less ideal – see below)
Infill: 25% with a triangular pattern
Supports: Not required
Brim/Raft: Brim recommended for better bed adhesion when using TPU
If you choose to print in PLA, keep in mind that the model will be more rigid, making it more likely to tip over or scratch surfaces. TPU provides better grip and a softer touch, which is especially useful if the object will be in contact with smooth or delicate surfaces.
Make sure your printer is well-tuned for TPU – slower print speeds (30–40 mm/s), a direct drive extruder, and good bed adhesion are key for a clean result. Let the layer lines show, but keep them consistent and tidy – this gives the print a sleek, intentional look.
Feel free to share a make or leave feedback!
Recommended Material: TPU
Alternative Material: PLA (works, but less ideal – see below)
Infill: 25% with a triangular pattern
Supports: Not required
Brim/Raft: Brim recommended for better bed adhesion when using TPU
If you choose to print in PLA, keep in mind that the model will be more rigid, making it more likely to tip over or scratch surfaces. TPU provides better grip and a softer touch, which is especially useful if the object will be in contact with smooth or delicate surfaces.
Make sure your printer is well-tuned for TPU – slower print speeds (30–40 mm/s), a direct drive extruder, and good bed adhesion are key for a clean result. Let the layer lines show, but keep them consistent and tidy – this gives the print a sleek, intentional look.
Feel free to share a make or leave feedback!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
