Thingiverse
Crest toothpaste refill
door Infinite-Pressure158
92
Downloads
301
Likes
0
Makes
A simple connector to fill your travel toothpaste from your home tube.
When fully screwed on to both tubes, the tips are designed to touch, which means no cleaning of the connector is needed.
Directions for use:
Squeeze as much air out of the receiving tube and screw the dispensing tube onto the connector and bottoms out on the tip of the receiving tube.
Fill the receiving tube and remove from the connector.
Made with PLA filament unless you plan on cleaning in hot water, then use a more heat tolerant filament such as ABS.
When fully screwed on to both tubes, the tips are designed to touch, which means no cleaning of the connector is needed.
Directions for use:
Squeeze as much air out of the receiving tube and screw the dispensing tube onto the connector and bottoms out on the tip of the receiving tube.
Fill the receiving tube and remove from the connector.
Made with PLA filament unless you plan on cleaning in hot water, then use a more heat tolerant filament such as ABS.
Infinite-Pressure158 publiceert ook op
10 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
