Cricut Joy Xtra Mat Guide

This is a guide strip for the cutting mat on the Cricut Joy Xtra cutter. It slides over top of one of the existing guide bumpers to tighten up and better align the cutting mat. If you've ever tried to cut with the Cricut Joy Xtra, you've probably had the annoyance of the cutting mat being misaligned with the rollers. The mat feeds into the rollers crooked and you have to try again.. and again.. and again to try and get it lined up perfectly. Hopefully you didn't crumple or crease your cutting mat in the process. This small printed guide rail sits on top of one of the existing guide bumpers to tighten up the mat space by just 2mm and makes the cutting mat run much straighter into the Cricut rollers. Just set the guide on top of the existing bumper, hold it on with your thumb, then feed in the cutting mat. I intentionally put the slot in the guide off center so you can choose to tighten up the mat slot by either 2mm or 1.5mm by flipping over the guide. I printed it in PLA, but any filame