Thingiverse
Critter Carabiner hold down
door Junkion_Mechanic
11
Downloads
5
Likes
0
Makes
Design based on the Kong Frog.
This is NOT an emergency device.
No spring necessary for this device, but I am in the process of finding the most available spring that can be used with it.
Best used with set screws in the perimeter holes 1/2 inch or 6mm diameter by 12mm long
The best for the central hole is 5mm by 15mm round phillips with a hex nut.
print 2 of each part and stack as indicated.
This is NOT an emergency device.
No spring necessary for this device, but I am in the process of finding the most available spring that can be used with it.
Best used with set screws in the perimeter holes 1/2 inch or 6mm diameter by 12mm long
The best for the central hole is 5mm by 15mm round phillips with a hex nut.
print 2 of each part and stack as indicated.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!