Crochet Hook 10mm - Ergonomic

Ergonomic CROCHET Hook - 10mm (See my other sizes available) I've had fantastic success rate printing my crochet hook designs. It's vital that you use a clean plate and some liquid glue to ensure good adhesion. I use pla and have found silk gives such a lovely smooth finish. It uses 21g of filament and takes approx 2 hours to print. This is well tested on my X1C printer. It's overall length is 19cm. I've written some instructions below to get best results: Follow these simple steps for great results…Always print in a silk filament - it will give the smoothest finishWork with a properly cleaned printing plate and some adhesive on the plateI've embedded the print settings in the file so you will notice that there is no seam (line) along any side, it is set to random seam to avoid the raised line down the length of the hook. This produces a visibly different finish but in no way affects the smoothness of the print. You can always change this setting in Bambu Studio if