Crochet Hook 6mm - Ergonomic

DescriptionErgonomic CROCHET Hook - 6mm (See my other sizes available) I've had fantastic success rate printing my crochet hook designs. It's vital that you use a clean plate and some liquid glue to ensure good adhesion. I use pla and have found silk gives such a lovely smooth finish. It uses 21g of filament and takes approx 2 hours to print. This is well tested on my X1C printer. It's overall length is 19cm. I've written some instructions below to get best results: Follow these simple steps for great results…Always print in a silk filament - it will give the smoothest finishWork with a properly cleaned printing plate and some adhesive on the plateI've moved the seam (line) to the back, you can change this if you prefer in Bambu Studio but I found it is visibly nicer and you do not notice it at all in your hand. FINISHING REQUIRED…You may need to give the hook and shaft some gentle sanding - this depends on your printer and or filament you chose. For the rounded fro