Crochet Hook for Knitting Loom

This is minimally modified from https://www.thingiverse.com/thing:53854

I wanted the tip width to be 3 mm. The overall diameter is 6 mm, so I made the narrowing angle to be 0.25 (25% from each side). This same result could be achieved by using the customizer on the original part and entering these values.

I wanted this width so that the tip could go through the slots of a knitting loom I am using, from here: https://www.thingiverse.com/thing:1242253

Mine printed reasonably well without supports.