Crock Pot replacement knob

This was a fun little project to make a replacement knob for my Mom's beloved Crock Pot that finally cracked after 1000 years of use. The model number is 3753-140-190, in case you were wondering if it would fit yours.

Printed in PLA, .2m layer height, .4mm nozzle. I had the best result printing the front side up, and the back side touching the build plate. I also used the custom supports plugin by Krasimir Stefanov in Cura to prevent it from generating unnecessary support where the switch shaft slides in. Honeslty, you could even make the backside flush and print with no supports at all. I was just trying to keep it close to the original part.