Crocs Jibbit/Charm Base

This is a NO SUPPORTS NEEDED base for a crocs jibbitz/charm.

My nephew asked if I could print him a soccer jibbitz/charm for his crocs. I said sure, but then I couldn't find a jibbitz base to print without the need for supports. Even though they all say no supports needed. I must've printed 10 different jibbit bases and each one, no matter which way I had it in the slicer (Cura) my printer would start printing into thin air when it got to the top platform part.

ANYWAYS... I designed this one in Shapr3D and it really does print without any supports. I thought I would be nice and share incase someone is having the same problem I was.

Place in slicer just as it's pictured. In about 10 minutes you'll have a base for a jibbitz charm to put on your ugly crocs.

Also, I printed this at .28 res, with a 50% infill, but my guess is that if you printed it at .16 res and 100% infill, it would look a lot better than the one in the photo.