Thingiverse
Cross plate for 2020
von Bobnet
36
Downloads
22
Likes
1
Makes
90 degree cross joining plates for C-Slot, V-Slot & similar Series 5 extrusions.
Not for MakerSlide!
STL's are designed to self tap using an M5 and the plates are 4mm thick. The holes are 5.5mm dia. Use a 10mm or 12mm low profile M5 to self tap the printed part. Spin the T-Nuts on, insert into the profile and then tighten down.
(at some point) DXF's have a 6mm hole for M5.
Not for MakerSlide!
STL's are designed to self tap using an M5 and the plates are 4mm thick. The holes are 5.5mm dia. Use a 10mm or 12mm low profile M5 to self tap the printed part. Spin the T-Nuts on, insert into the profile and then tighten down.
(at some point) DXF's have a 6mm hole for M5.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
