Thingiverse
Cross Plectrum
von AWS3D
19
Downloads
9
Likes
0
Makes
Simple guitar plectrum (hard pick) with a cross on both sides of it PLA works good just make sure your combing is on and coasting is slightly under extruding so there are no blobs. Adjust support xy as needed with xy overrides z.
If you would like the fusion file for my designs consider supporting me with a tip on thingiverse and send me an email.
If you would like the fusion file for my designs consider supporting me with a tip on thingiverse and send me an email.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
