Thingiverse
Cross RC BC8 Electronics Mounts
von jengebos
21
Downloads
15
Likes
0
Makes
Boards designed to clean up the mounting and wiring inside the Cross BC8 Mammoth.
I will keep adding to this as I get them done and tested.
The RX_ESC mounts the Spektrum SRS6000 6 channel receiver below the HobbyWing 1080 ESC. It uses 3mm x 8mm screws to secure the top and servo tape to secure the ESC.
There is also a hole to route the antenna wire through into some 3mm rx tube.
The Sound_Lighting_Servo print stacks the Cross sound module with the lighting pc board and the servo power board. the screws are M3 for the sound module and power board. The H shaped cover over the lighting PCB uses M2.
I will keep adding to this as I get them done and tested.
The RX_ESC mounts the Spektrum SRS6000 6 channel receiver below the HobbyWing 1080 ESC. It uses 3mm x 8mm screws to secure the top and servo tape to secure the ESC.
There is also a hole to route the antenna wire through into some 3mm rx tube.
The Sound_Lighting_Servo print stacks the Cross sound module with the lighting pc board and the servo power board. the screws are M3 for the sound module and power board. The H shaped cover over the lighting PCB uses M2.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
