Cross Slide Vise Handle

*** If you use this design and it works well for you, please consider $1 Tip to the Designer. It's only a buck to help support the creations. Thanks in advance! ***

Bought a used drill press that came with an xy table, or cross-slide table. Very handy but it was missing a single spinny handle knob thingy (technical term) for the y-axis.
Made this to fit and liked it so much that I printed another to replace the x-axis as well.

Square thru cut is 0.31" x 0.31" for the axis shaft mount.
Use a 1/4"-20 nylon lock nut and screw to assemble the handle (tight enough to hold but loose enough to allow the spinning action).

Enjoy!