Thingiverse
Crossfire Nano RX Jacket Case
di caseyjholmes
124
Download
80
Likes
0
Makes
Edit:
V2 has been added 10/26/18 with a hole in the bottom for removal by pushing the RX out with a plastic tool.
Small jacket case to hold your antenna on the TBS Crossfire Nano RX so the antenna doesn't pop off. Also lets you insulate and mount the receiver with double sided tape to your models and has wire cutouts. just seal with tape when you insert the receiver to keep dust out and install inside your model! Enjoy! =)
To install:
Snap antenna to connector. Solder four wires to receiver for power, ground, input and output rx. Slip antenna connector end of nano RX into housing first and push it back until wire side of nano rx slips into the box. Then you can twist the antenna wire into the locking slot in the housing to ensure your antenna won't pop off during flight.
This allows you to mount your receiver without using any adhesives on the receiver itself. Very clean install.
-Casey
V2 has been added 10/26/18 with a hole in the bottom for removal by pushing the RX out with a plastic tool.
Small jacket case to hold your antenna on the TBS Crossfire Nano RX so the antenna doesn't pop off. Also lets you insulate and mount the receiver with double sided tape to your models and has wire cutouts. just seal with tape when you insert the receiver to keep dust out and install inside your model! Enjoy! =)
To install:
Snap antenna to connector. Solder four wires to receiver for power, ground, input and output rx. Slip antenna connector end of nano RX into housing first and push it back until wire side of nano rx slips into the box. Then you can twist the antenna wire into the locking slot in the housing to ensure your antenna won't pop off during flight.
This allows you to mount your receiver without using any adhesives on the receiver itself. Very clean install.
-Casey
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
