Crow Ornate

by Corp · Hueforge & Lithophane

44 Downloads

48 Likes

24 Makes

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 100x100mm in size. You can adjust the X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.1mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 2.5PLA BambuLab Basic Gray Transmission Distance: 3PLA BambuLab Basic White Transmission Distance: 6This print uses 4 unique filaments. Substitute to your own needs. Swap Instructions:Start with BlackAt layer #9 (0.8mm) swap to Blue GrayAt layer #16 (1.36mm) swap to GrayAt layer #20 (1.68mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!