Thingiverse
Crown Headgear
por alreadytom
0
Descargas
0
Likes
0
Makes
This 3d print will fit a 4mm ring normally found at hobby lobby. We used the 100mm ring and
cut out a section until it would not vise on to our head. Then using a hot glue gun we are able to secure the ring from falling forward or backwards. some reaming is done to ensure there is a tight fit... I use a drill bit and just turned it by hand until i was able to have a snug fit with the
3d printed part and the cut section of the ring.
cut out a section until it would not vise on to our head. Then using a hot glue gun we are able to secure the ring from falling forward or backwards. some reaming is done to ensure there is a tight fit... I use a drill bit and just turned it by hand until i was able to have a snug fit with the
3d printed part and the cut section of the ring.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
