Thingiverse
Crowtail Capacitive Moisture Sensor V2.0 case
door kadn
5
Downloads
3
Likes
0
Makes
Four (4) enumerated cases for Elcrow Crowtail-Capacitive Moisture V2.0/V2.1 sensors. These cases are better fitting and don't need any extra trimming with a blade to fit the board inside.
You'll need a total of 16 M3x8mm screws with countersunk heads (4 per case), and there's no need for counter nuts. The cable hole is about 4 mm wide, so it fits custom cables snugly.
I recommend using the included .gcode file because it has support structures for the parts, so you don't have to worry about extra work around the screw holes.
I used a custom cable that I soldered right into the circuit of the moisture sensor.
You'll need a total of 16 M3x8mm screws with countersunk heads (4 per case), and there's no need for counter nuts. The cable hole is about 4 mm wide, so it fits custom cables snugly.
I recommend using the included .gcode file because it has support structures for the parts, so you don't have to worry about extra work around the screw holes.
I used a custom cable that I soldered right into the circuit of the moisture sensor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
