Crystal ball HueForge

Picture source/author: SandySarten @sandysarten Then used HueForge v0.8.1 to create the model.   Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. The Model is 150x150mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.08mm and the Actual Depth is 2.08mm   It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   Filaments Used: PLA Anycubic Black Transmission Distance: 0.3 PLA Elegoo + Orange Transmission Distance: 6 PLA Elegoo + Yellow Transmission Distance: 4 PLA Elegoo Basic White Transmission Distance: 7 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Orange At layer #11 (0.96mm) swap to Yellow At layer #13 (1.12mm) swap to White for the rest.