Thingiverse
Crystal Lamp
11
Downloads
7
Likes
0
Makes
This is a crystal lamp I made in 123d autodesk, don't use this for commercial stuff ect.
Assembly:
Print all the parts and then just slide the crystal part into the base and secure it with glue, I used gorilla glue and its holding up well. Afterwards this is optional in my opinion but you can glue the base ring to where the crystal meets the base, I think it looks better that way.
NOTE: make the base slightly larger than the crystal or it won't fit. you have been warned.
Assembly:
Print all the parts and then just slide the crystal part into the base and secure it with glue, I used gorilla glue and its holding up well. Afterwards this is optional in my opinion but you can glue the base ring to where the crystal meets the base, I think it looks better that way.
NOTE: make the base slightly larger than the crystal or it won't fit. you have been warned.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
