Thingiverse
Crystal LED Light
von Mike-vom-Mars
1.9k
Downloads
1.7k
Likes
11
Makes
Crystal LED Light
Crystal sculpture with a bottom hole (diameter 66.8mm) to hold a LED light gadget.
I used the LEDs and battery holders from LED candles (similar to these: http://ebay.to/2tZLjF1 ), so the lamp can be set to different colors via a small remote control.
Customized thing of the original crystal sculpture by JustinSDK:
https://www.thingiverse.com/thing:1729963
Printing:
- No infill
- No supports
- Use transparent PLA
- Wall thickness 0.8mm
- Layer height 0.3mm (or less)
- Use raft for best adhesion
Tuning:
- Use stone / granite effect spray to paint the base
- Apply glue on some places and spread some model makers' grass on it
Crystal sculpture with a bottom hole (diameter 66.8mm) to hold a LED light gadget.
I used the LEDs and battery holders from LED candles (similar to these: http://ebay.to/2tZLjF1 ), so the lamp can be set to different colors via a small remote control.
Customized thing of the original crystal sculpture by JustinSDK:
https://www.thingiverse.com/thing:1729963
Printing:
- No infill
- No supports
- Use transparent PLA
- Wall thickness 0.8mm
- Layer height 0.3mm (or less)
- Use raft for best adhesion
Tuning:
- Use stone / granite effect spray to paint the base
- Apply glue on some places and spread some model makers' grass on it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
