Crystal Wall Sconce with E12 Bulb Fitting

This is a mix of several different models I found on the web. The original sconce was just for a candle or tealight but I wanted a glowing crystal. The candle tray has been adapted to fit a standard E12 1" socket that you would use in a salt lamp or model houses. A list of all of the supplies will be below. I've also added a small channel down the sconce arm for the electrical cord to fit into to keep it discreet. The crystals were adaptations of several different crystal cluster models I found in an attempt to make the inside large enough to house the bulb. SuppliesIn addition to printing the model pieces, you will need:An E12 Socket with outlet cord. I got mine off of amazon here.An E12 bulb of your choice, I got these LED Flame bulbs.SuperglueAssembly InstructionsPrint all three plates from the 3MF file I've uploaded. The arm has some necessary modifications in place to create the channels as well as to provide better structural integrity at the joints that will bear the