CTC Bizer Quickdraw Probe Mount and Dock

I wanted a detachable probe, found the quickdraw but realized that there was no mount or dock suitable...so I fixed that. This docks at -2 X 0 Y (front left)

You will need:

6x small round Neodymium magnets (6mmx3mm)
3x M3 20mm plus nut
Some wire
3-pin endstop micro switch without the lever.

The STL for the probe itself can be found below:
https://github.com/Annex-Engineering/Quickdraw_Probe

I'll upload my Klipper config when I get a chance.

This will probably also work for any of the Replicator printers.