CTC nut cover / holder

Remixed from the m3 Wing Nut by Dr_3d - thank you for the jump start!

I originally remixed these to keep the nuts on my CTC from digging down into the particle board when tightening the exterior screws. Coincidentally they also work very well for holding the nuts in place when disassembling/reassembling the bot.

In most cases, one of the thin edges will need to be removed for the perfect fit. (pictured) One of the edges should be particularly easy to remove - again by coincidence, one of the corners didn't join all the way on my model.

This .stl file contains 40 nut covers, which should be enough to cover all of the visible nuts - plus a couple extra (for the bottom of the bot).

Printed in PLA
.20mm layers
100% infill
no raft/supports