Cthulhu Puzzle Box

edit: updated the L_Gear file, apparently it was a factor 10 bigger than it should

I lost all my documentation so from scratch and alas less detailed.

First off, this is a remix of juangrs' box which I liked but though I could do better and saw this as a good fusion 3D exercise. Hence EVERYTHING has been created from scratch but based on the design of juangrs with some changes like:
- fully closed lid (so the magnet cannot leave the lid!)
- print in place magnets in the side circles
- tighter lock
- indents for the circles
- print in place hinges (well at least for the bottom part)
- print in place shafts (with supports)
- easier assembly.

Most notably I've extended the puzzle with additional material, I created an excel sheet so you could create your own maze system but that one got lost in the grand clean up, maybe I remake it and upload it.

### ASSEMBLY:
you can have a look at the doc that juangrs created but ill add some pics which shows what goes where. I was