MakerWorld

Robotics

CTRE Pigeon 2 Mount

von Cal · Robotics

63 Downloads

5 Likes

23 Makes

Mount for the CTRE Pigeon 2 with #10 holes on a 2" spacing. The center of the Pigeon is centered between the mounting holes. I designed this to make mounting the pigeon to punched tubing or perforated polycarbonate sheets easier and add some protection to the Pigeon. The holes have a 3/8" hex pocket to be used with a #10 nut, or as a counterbore for a #10 button head screw. The Pigeon is attached to the mount with zip ties and prevented from moving with the outer walls. Additionally some double sided adhesive can be used underneath the Pigeon, but I did not find this necessary.

first robotics competition cross the road electronics mount pigeon imu frc gyro ziptie zip tie

Kategorie

Robotics

Quelle

MakerWorld

Veröffentlicht

08.10.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

aufwändige Nachbearbeitung

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 2/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Nachbearbeitung

Kleben, Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

CTRE Pigeon 2 Mount

Ähnliche Modelle

Zur Sammlung hinzufügen