Cube Maze (No Dead Ends)

This maze is designed for a 5/16" (8mm) ball bearing. I've included a tool that will help hold the sides when gluing them together. You'll still want to put rubber bands around the whole thing, to keep it held together tightly, until the glue dries. I suggest you have a couple trial runs on putting the pieces together before applying glue. It can be a little difficult. I found that putting the bottom side on a flat surface and using it as a base to hold the sides, works the best. It isn't necessary to glue all the pieces at the same time . Glue two sides together and assemble the cube. Let it sit until it dries and then glue another piece on and then let that dry. Don't be in a hurry and don't forget to put the ball in before gluing the last side.

1/5/21
Fixed an error that existed in the side labeled TOP.