Cubic Enclosure

Enclosure with wooden edges and thin plastic panels with a black iron pipe base. It's around $50 for the panels, another $100 for the wood, and $150 for the pipe. In Canadian dollars.

I used 8 1.5" x 3/4" x 8' boards glued together to form 1.5 " x 1.5" x 8' boards using a dozen of the 1.5clips I printed off to keep the edges together and clean. Ensure you have 2' by 2' thin plastic panels, sometimes there is a quarter inch extra along a dimension, the slot will be deep enough that if you rough cut it on a table saw, it won't be visible. Print 4 or the corners for the top and 4 for the bottom, not critical but there is no bottom panel and the fillets are inverted so it can be bolted down if you wish. Test fit a panel with a corner on either end to get the measurement each wooden edge has to be, err on longer. They will all be cut to the same size, so check it several times. Once you have 12 bits of wood you need to do a practice cut a few times with some scrap with a table saw or