Thingiverse
Cuckoo CRP-HW1087F
von allthemoose
1
Downloads
0
Likes
0
Makes
My Cuckoo Rice cooker (Model CRP-HW-1087F has been very reliable but the latch holding the lid down broke. The first time, super glue was suitable to fix this. Second time round not so much.
I tried to print the model from @jsledge here
https://www.thingiverse.com/thing:4237626
but this is for a different model so didnt work for me.
This was remodelled in Fusion 360 using some rough measurements of the existing part and 2 iterations of the design the get it right. Seems to work great and fits well.
Re-use the spring from the existing part.
I used Prusa Slicer to add 100% infill just on the pins on the end as these tend to break and are the weakest part of the design.
I tried to print the model from @jsledge here
https://www.thingiverse.com/thing:4237626
but this is for a different model so didnt work for me.
This was remodelled in Fusion 360 using some rough measurements of the existing part and 2 iterations of the design the get it right. Seems to work great and fits well.
Re-use the spring from the existing part.
I used Prusa Slicer to add 100% infill just on the pins on the end as these tend to break and are the weakest part of the design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
