Thingiverse

Cup Holder for Walker

von Tron-X

67 Downloads

64 Likes

0 Makes

This cup holder was made for a Dolomite walker. May fit other walkers as well if it has a strap that is 1 1/2 x 1/8" (38 x 3.2mm). Assemble with 3 sheet metal screws #6 x 1/2" (3.5 x 12mm). Two screws are installed from the outside (through the clip into the cup), one is installed from the inside (through the cup into the clip).

accessibility beverage beverage holder cup cup holder dolomite drink drink holder handicap Walker accessibility beverage beverage holder cup cup holder dolomite drink drink holder handicap Walker

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Cup Holder for Walker

Ähnliche Modelle

Zur Sammlung hinzufügen