Cup Hut - Keep Crap Out

Cup Hut – Keep Crap Out Looking for a safe place to park your favorite mug between sips? The Cup Hut is a simple 3D-printable shelter designed to help keep dust, debris, and everyday desk clutter out of your coffee, tea, or hot chocolate while adding a little fun to your workspace. The open-front design makes it easy to slide your mug in and out, while the sloped roof helps shield your drink from whatever may be floating around your desk. Whether you're working in a busy office, a workshop, or your home workspace, the Cup Hut gives your mug a place to call home. Features: Fits most standard coffee mugs up to approximately 4" (102 mm) tall Simple multi-part design for easy printing No hardware required Quick and easy assembly Compact footprint Fun workshop-inspired styling Perfect for: Coffee lovers Tea drinkers Home offices Workshops Gifts for coworkers and friends Cup Hut. Keep Crap Out. Cup Hut Assembly Instructions Before You Begin Inspect all printed parts. Deburr and clean up any rough edges or stringing as needed. Dry-fit the parts before applying glue to ensure everything fits properly. Recommended Adhesive I recommend Gorilla Glue with the precision dropper tip and brush applicator. Only a few small drops of glue are required at each joint. https://amzn.to/3SCCihb is an Amazon affiliate link, no additional cost to you. Assembly Surface For best results, place a sheet of parchment paper on a flat cutting board or work surface. This helps prevent parts from sticking to the table and makes it easier to keep everything square during assembly. Step 1 – Assemble the Side Walls Attach the side walls to the corner columns first. Slide each wall fully into the corner grooves. Ensure the walls are seated completely against the columns. Apply a few small drops of glue at strategic locations inside the joints. Allow the assembly to remain flat and square while the glue sets. Step 2 – Install the Back Wall Attach the back wall to the assembled side walls and columns. Mak