Thingiverse
Cupboard plate rack
di bracco23
3.7k
Download
2.6k
Likes
1
Makes
This is a small modular plate rack I designed to organize the plates in my cupboard.
it is designed with a 20mm space between each "spine", with a 10mm width and a 30° angle.
Each segment has 4 spaces for plates, and a front and/or back joint to connect it to other pieces, in particular:
- front only has the back joint
- back only has the front joint
- middle has both
the top of the joint is measured to receive an M3 nut, with the other piece sliding inside and an M3 bolt coming from under to secure. I used M3x16, without tightening all the way to have the bolt sit flush.
Two pieces are joined by a link that fits in the hole in the middle. All tolerances are 0.1mm which on my printer makes it fit snug.
it is designed with a 20mm space between each "spine", with a 10mm width and a 30° angle.
Each segment has 4 spaces for plates, and a front and/or back joint to connect it to other pieces, in particular:
- front only has the back joint
- back only has the front joint
- middle has both
the top of the joint is measured to receive an M3 nut, with the other piece sliding inside and an M3 bolt coming from under to secure. I used M3x16, without tightening all the way to have the bolt sit flush.
Two pieces are joined by a link that fits in the hole in the middle. All tolerances are 0.1mm which on my printer makes it fit snug.
bracco23 pubblica anche su
3 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
