MakerWorld
Coin & Badges
Go to Model
Cuphead keychain (double sided, uses AMS)
138
Downloads
47
Likes
84
Makes
Made Forest87's fridge magnet into a double-sided keychain.I much prefer face down prints for these types of things, so both sides are face down and get glued together. There are small squares that insert into the inside to help with alignment. Use superglue, and I suggest you clamp the two sides together for ~10 minutes while it sets.The squares should be small enough to fit just fine, but you can make them a little smaller if the tolerance is too tight.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
