Thingiverse
Curtain_rail_end
von nanoBorg88
0
Downloads
0
Likes
0
Makes
An duplicate of a missing curtain rail end. Used for one of the metal type ones,
the opening inside should be good for 6mm thick 22mm width extrusion.
Has a hole to put a 3mm screw to hold it in place, but the hole might need to be drilled out a little for the screw fit easily.
This has a loops for the last hook to lock in.
Print with the end and the loop on the bed so the open end is facing up.
the opening inside should be good for 6mm thick 22mm width extrusion.
Has a hole to put a 3mm screw to hold it in place, but the hole might need to be drilled out a little for the screw fit easily.
This has a loops for the last hook to lock in.
Print with the end and the loop on the bed so the open end is facing up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
