Curtain Rod Mount

I designed this curtain rod mount as a simple, reliable solution for mounting a standard curtain rod to either the ceiling or close to a wall. The hole for the rod is 30mm, making it an easy fit for common 28mm curtain rods. This is Version 1 of the design — straightforward, practical, and ready to use. Filaments (suggested):PLA, PETG, or ABS depending on your environmentPLA: indoor use, easiest to printPETG: better strength and heat resistanceABS: best for higher temp or sun-exposed areasSpecial Print Instructions:No supports requiredPrint orientation: on it's sideInfill: 20–30% is more than enough for strength (i used the standard 15% and it works fine)Layer height: 0.2mm recommended (standard)Non-Printed Parts:#6 – 1" Flat Head Wood Screw (recommended)Hole diameter is 3mmAssembly IntroAssembly is very straightforward. You’ll need only a screwdriver and the correct screws. The mount can be installed directly into wood, drywall with anchors, or ceiling beams. InstructionsPrint