Thingiverse
curtain tie
por andrewgm
3
Descargas
3
Likes
1
Makes
Three slightly different curtain ties. Each design prints 2 so that they are the support for each other.
There is a .5 mm gap between the 2 curtain ties. Scaling it down to work with smaller amounts of curtains worked for me at 75% but I haven't tried any smaller.
I was going to make them taller with more wraps but the test prints were hard to get on and off the curtains.
There is a .5 mm gap between the 2 curtain ties. Scaling it down to work with smaller amounts of curtains worked for me at 75% but I haven't tried any smaller.
I was going to make them taller with more wraps but the test prints were hard to get on and off the curtains.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
