Thingiverse
Curvy Caltrop
by vik
27
Downloads
18
Likes
0
Makes
This is an artistic, curvy caltrop assembled from two identical lasercut halves. However it lands, one point always points straight up. The file was designed to cope with 3mm acrylic or MDF with a bit of wriggle-room.
These are designed for leaving around on Halloween displays and look best cut in clear acrylic with backlighting. Don't leave them lying around on the ground because they hurt worse than a L3go if you step on them!
These are designed for leaving around on Halloween displays and look best cut in clear acrylic with backlighting. Don't leave them lying around on the ground because they hurt worse than a L3go if you step on them!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
