Thingiverse
Customisable Module Socket for ESP8266 HC-05 etc
von WDWHITE
1k
Downloads
735
Likes
2
Makes
I've tried to make a customizable socket to fit any module you are trying to Program such as the ESP8266 wifi module or a HC-05 bluetooth module. Prity much any module that is based on being a board to be surface mounted.
The open SCAD file assumes that the left and right sides are mirrored and that if there are pins along the top then they are mirrored to the bottom.
The pins were sourced from a bag of different IC sockets. I broke apart the socket to recover the pins, then Straightened the legs of the pins. I found that sockets designed as through hole worked better for these sockets even if I intended the socket to be surface mounted.
In the end I used pins from a 84 pin PLCC socket search for "PLCC IC Socket" I chose a socket with through hole pins and a pin spacing of 2.54mm / 0.1 inch
The Open SCAD file can generate SVG files with the outline of the socket any holes needed and the placement of any copper pads. With that you will be able to then generate your own custo
The open SCAD file assumes that the left and right sides are mirrored and that if there are pins along the top then they are mirrored to the bottom.
The pins were sourced from a bag of different IC sockets. I broke apart the socket to recover the pins, then Straightened the legs of the pins. I found that sockets designed as through hole worked better for these sockets even if I intended the socket to be surface mounted.
In the end I used pins from a 84 pin PLCC socket search for "PLCC IC Socket" I chose a socket with through hole pins and a pin spacing of 2.54mm / 0.1 inch
The Open SCAD file can generate SVG files with the outline of the socket any holes needed and the placement of any copper pads. With that you will be able to then generate your own custo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
