Thingiverse
Customisable Square/Triangle key
von MasterKey3
19
Downloads
8
Likes
0
Makes
This is a preset for a utility key that you can fully customize. It is set up for the key to be very easy to print without support, regardless of your adjustments.
A few things should be noted:
-This model is set up for use in milimeters
-Handle length is measured from the wall of the cylinder to the tip of the handle end.
-When using double hadles, each handle has the set length.
-The size of the bottom of the hole is: Hole_size – Hole_draft.
Please feel free to post a comment, remix or your print results!
A few things should be noted:
-This model is set up for use in milimeters
-Handle length is measured from the wall of the cylinder to the tip of the handle end.
-When using double hadles, each handle has the set length.
-The size of the bottom of the hole is: Hole_size – Hole_draft.
Please feel free to post a comment, remix or your print results!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
