Customizable AMS Cable Magnet Holder

While printing (especially when printing infills !!), the constant slapping sound of the AMS cable slapping the back panel or shelf wall was very annoying. Most AMS cable management models are designed to organize cables by winding up excess length, which didn't suit my needs.So I designed a simple holder to keep the cables separated from the rear panel of the printer. It's a simple straight-line structure, but I designed it to be customizable to the desired length and height,and to fit the type of circular magnet you have. Length and height can be adjusted up to 100mm,circular magnets can be adjusted for diameters from 1mm to 10mm,and thicknesses from 0.5T to 10T. Magnet slot is tight fit, for not to use glue.Place your magnet on table, and press this holder from above. It'll fit into place with little force. It should be usable on any surface where magnets adhere. If this model proves useful to many,I'm considering designing a 90-degree angled version as well. I hope