Customizable Aquarium Planter

## General
I was looking for a some basic planters for my aquarium, but wanted to be able to *relatively* easily customize them. End goal is to create some corners that allow for tubing, cords, etc to run behind.

### Printing
The **small** difference between the smaller radius and larger radius of the pin allows for it to be printed vertically with either end on the bottom. The basket should be printed with the opening at the top. I did not have any issues with the hex diameter at 6mm and based on the angles should be fine to scale that up or down to suit needs without any print setting mods. For this I just used Cura's *Standard Quality - 0.2mm* PLA profile. Should print fine at other resolutions, just didn't think anything else was necessary.

**NOTE:** Make sure that the hex walls have an angle at the top when designing your own. That is how the bevel pins are oriented. Walls with the hex angles oriented to the sides instead of the top will not mount to the aquarium lid