Customizable box with lid, latch and separators

Parametric rewrite of my old model (https://makerworld.com/en/models/598301).Prints without supports and any additional parts, you can just insert the lid into box.For separators and customizations please visit parametric model generator.Tested print with Bambu PLA, for other filaments some tolerance adjustments may be needed.Boost MeBoost to support me and motivate me to do more parametric modelsSeparators explained:The first letter can be either v or h - that means vertical or horizontal separator.After that, there's a number - offset in mm from the left side.Next number is offset in mm from the top side.Next is either a number or letter f - it can be the length of the separator in mm, letter f means it just takes full width if it's horizontal or full height if it's vertical.Next is the same but about the height of the separator from the bottom.Each term is separated by commas, and if you need multiple box separators you just write them in line with spaces in between. The