Thingiverse
Electronics
Go to Model
Customizable ESP32 lateral support
188
Downloads
112
Likes
0
Makes
I had wanted to have access to boot, reset buttons and pins at the same time.
So I decide to make lateral support.
Since there is no much space for screws, there are pins that since they are very small, they will not print very well.
There is an option by default to use clips.
In OpenSCAD and FreeCAD file, you can modify the parameters, There are lots of variants of these development kits, so measure yours, enter the values in the dimensions spread sheet and export to stl.
So I decide to make lateral support.
Since there is no much space for screws, there are pins that since they are very small, they will not print very well.
There is an option by default to use clips.
In OpenSCAD and FreeCAD file, you can modify the parameters, There are lots of variants of these development kits, so measure yours, enter the values in the dimensions spread sheet and export to stl.
plbarrio also publishes on
43 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
