Customizable Pinball Machine

This pinball machine stands out because it's customizable! Place one of the obstacles anywhere on the board, and make your own obstacles! NON 3D PRINTED PARTS: -2 loom bands -metal ball (less than 1/2 in) INSTRUCTIONS: Print the PinBoard and Rails files, then snap the rails on on the side of the board that faced the bed while printing. Glue if needed. Print 2 feet and snap them on the bottom of the board. Print ONE of EACH FLIPPER and two flipper axles. Attach the flippers by putting the axles through the big holes on the board, and snapping the flippers on top. Print two pushers and put them in their slots with the bigger end facing INWARD. Use the rubber bands to attach the little pegs on the flippers to the pegs on the rails. Print the starter and the starter axle. Position the starter between the two rings on the board, and nap the axle in place. glue axle if necessary. Print as many tricks as you like. Most of them just snap into the holes on top, but the spinner snaps in like the flippers. If there are leftover holes, print covers for them (or just consider them tricks ). TIPS: Make sure the ball never gets stuck going down, leave plenty of space between tricks. if the pushers aren't working, just take the rubber bands off and flick the flippers directly with your fingers :) You might need to glue down a couple of trick so they don't fly off when hit. Have fun building this project!