Slicer Discord
Customizable Rhombic Dice – 3D-Druckmodell von Thingiverse Thingiverse

Customizable Rhombic Dice

177 Downloads
111 Likes
0 Makes
Zum Modell
This is a Rhombic 12 sided dice. The Customizer lets you place up to 12 characters of text along the long diagonal of each side.

[ *** IMPORTANT ***]
I cannot stress this enough. This dice has 12 sides but there are only 6 text lines. You enter two messages in one line by separating the messages with a "/". If you leave off the "/" you will get two blank sides. I did this so that I could pair messages on opposite sides of the dice.

The roundness slider lets you round over the edges and corners so they are not so sharp. Set it to zero to get sharp edges.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen