Thingiverse
Customizable Rokenbok Beam
von nickmo
20
Downloads
8
Likes
0
Makes
A customizable file to create Rokenbok blocks and beams with variable length and with optional snaps on one or both sides. This is a work in progress and the snap fits may or may not work depending on the type of printer.
The optional supports are designed for single extruder printers for minimal, easy to remove (with needle-nose pliers) supports. Be careful when removing the supports, PLA shards can be sharp.
Tested with the following setup:
*Printer: Replicator 2 (PLA)
*Layer height: 0.2mm
This is a hobby part, always print with adult supervision.
The optional supports are designed for single extruder printers for minimal, easy to remove (with needle-nose pliers) supports. Be careful when removing the supports, PLA shards can be sharp.
Tested with the following setup:
*Printer: Replicator 2 (PLA)
*Layer height: 0.2mm
This is a hobby part, always print with adult supervision.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
