Thingiverse
Customizable Sink Snake
por crashdebug
424
Descargas
271
Likes
0
Makes
Found this [original sink snake design](https://www.thingiverse.com/thing:40893) from 2013 a few days ago and was thinking about how to make it parametric. It was a good OpenSCAD exercise.
**Now you can finally print your unique and super long sink snake!**
If you print it with PLA soften it with hot water to straighten it out, be careful not to break it in use. I take no responsibility for any harm done to your sink ;). More durable materials like nylon may be better suited if you have them available.
*Don't use it as a whip please.*
___
**Update Oct. 19th 2018**
Added an option to show the total length (without handle) in either mm or inch.
**Update Oct. 20th 2018**
As this seems quite popular I've updated it again:
* Tooth lean is now calculated more accurately for a small radius
* **Double sided** tooth generation is now possible. It looks fierce but single sided may be more practical and easier to pull out of the sink. Enjoy.
**Now you can finally print your unique and super long sink snake!**
If you print it with PLA soften it with hot water to straighten it out, be careful not to break it in use. I take no responsibility for any harm done to your sink ;). More durable materials like nylon may be better suited if you have them available.
*Don't use it as a whip please.*
___
**Update Oct. 19th 2018**
Added an option to show the total length (without handle) in either mm or inch.
**Update Oct. 20th 2018**
As this seems quite popular I've updated it again:
* Tooth lean is now calculated more accurately for a small radius
* **Double sided** tooth generation is now possible. It looks fierce but single sided may be more practical and easier to pull out of the sink. Enjoy.
crashdebug también publica en
28 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
