Thingiverse
Customizable SoftBox for NeoPixel-LED-Ring
von JKDesign
84
Downloads
76
Likes
1
Makes
Print your own softbox for a NeoPixel (WS2812) ring to build e.g. an analog clock.
Note: There are many manufacturers with different mechanical ring sizes. So use the customizer (or OpenSCAD direct) to adapt to your ring and design.
Optimized for single extruder 3D printer. Print from LED-mount up or down - both possible without support material.
Set 'RingInnerDiameter' and/or 'RingOuterrDiameter' to zero for no mounting domes. With domes use 3mm screws to hold the ring.
For more and diffuse light paint inside with silver or white ink.
As diffusor in front you can use a sheet of paper or an opal acryl.
Note: There are many manufacturers with different mechanical ring sizes. So use the customizer (or OpenSCAD direct) to adapt to your ring and design.
Optimized for single extruder 3D printer. Print from LED-mount up or down - both possible without support material.
Set 'RingInnerDiameter' and/or 'RingOuterrDiameter' to zero for no mounting domes. With domes use 3mm screws to hold the ring.
For more and diffuse light paint inside with silver or white ink.
As diffusor in front you can use a sheet of paper or an opal acryl.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
