Customizable Spiralized OpenSCAD Maze

It seems silly to make this derivative it's own thing but it was a required change to enable the OpenSCAD mazes to be printed with the "spiralize the outer contour" option checked under the Expert Settings in Cura (or similar mode in other slicers). I added a cylinder to the object to make it solid... you are then free to print only the single outer wall. I decided that I had to try this after printing the lid to the maze with the spiralize option (see object http://www.thingiverse.com/thing:1988521).

You might have to play with the measurements/scale slightly depending on your printer and settings. I printed the mazes and lids at 100% scale across the board as long as the lid and maze are made of the same material. If you are mixing/matching materials then you will have to scale of the items slightly up/down up to 2% depending on the material.

The example prints photographed above have the bottom 13mm cut off of them in Cura's settings and 3mm "solid" bottoms. This works well