Thingiverse
Customizable storage/components drawer
von DonJuanito
131
Downloads
88
Likes
0
Makes
A replacement storage/components box/drawer that you can customize.
Inspired by timfou's model : http://www.thingiverse.com/thing:2200136
Check or adjust the drawer parameters. you can add or remove dividers by editing the "DPos" vector.
Render the "Drawer", the "Handle" and the "Divider".
Print one of each (more dividers if needed) and assemble. You certainly will have to glue the sliders of the "Handle" in place.
All can be printed without supports, even if the bottom of the drawer might need some filing/sanding.
The source file is (heavily) commented...
**Note:** I still haven't printed this, but I cannot see why it would fail...
Inspired by timfou's model : http://www.thingiverse.com/thing:2200136
Check or adjust the drawer parameters. you can add or remove dividers by editing the "DPos" vector.
Render the "Drawer", the "Handle" and the "Divider".
Print one of each (more dividers if needed) and assemble. You certainly will have to glue the sliders of the "Handle" in place.
All can be printed without supports, even if the bottom of the drawer might need some filing/sanding.
The source file is (heavily) commented...
**Note:** I still haven't printed this, but I cannot see why it would fail...
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
