MakerWorld
Decor
Go to Model
Cute Fancy Penguin
3
Downloads
4
Likes
3
Makes
designed a fancy little penguin with a cane and tophat i also designed a low poly one which turned out so cute :D both use the same settings and are very easy to paint :) used cheap paint markers to paint it :) its 75mm tall uses very little support with using tree supports should come off very easily its printed upside down on the tophat at the base and should print in about 80,90 mins :) if you print one and paint it post a pic wanna see the little fancy penguin army grow :D thanks so much for looking and or reading this hope you have a good day :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
